Re: CoreCell Q: Model Yacht

I'm about to build my first model racing yacht out of machined CoreCell
covered with 2 oz glass outside and 3/4 oz glass inside, using
Aerospace Composites resin. This will be  a 36" LOA, 12 lb free sail
(vane steered, no radio) boat that has to be designed to take the
stress loads of hitting the  side of a pond when surfing under
spinnaker.

Current plans  are to hollow the hull  to 1/4" wall, with a 1" wide,
full depth "keel" running down the center, and gunwales widened to 1"
where the shrouds attach. The 9+  lb bulb will be removable, with two
1/8" stainless rods running up through carbon fiber tubes set in the
CoreCell "keel" and bolted at deck level. Back of the envelope
calculations suggest that this should yield a boat a bit lighter,  just
as strong, and much simpler to build than my current technique of
spruce scantlings inside a glass shell.

I am concerned about shroud/stay attachment, given the stress the rig
takes if/when it  whacks the side of the pond. With the spruce
scantlings I put 1/4" thick pads of Lexan under the kingplank and sheer
strakes and screw #4 stainless sheet  metal screws into them.  This has
never let go on me, even under the stress of some pretty horrific
collisions.

Having never worked with this stuff before, the only thing I can think
of is to inset the Lexan into the CoreCell and cover it with a couple
of layers of heavy glass. Anybody have any better ideas?

Any other cautions or advice welcome.

(FYI: This boat will be sailed at Gosport, England in late June, in the
biennial UK/USA free sailing free sailing and hospitality
championships.)

Cheers,

Earl