Re: Standard Horizon SL45 Knot Log Anomalies

You are accessing this site in a read-only mode. For full access to all member benefits, including message posting, please login or register. Registration is completely free, simple, and takes only a few seconds.

The message you are replying to and its parents are listed in the reverse order with the most recent posts first. This might not be the whole discussion thread. To read all the messages in this thread please click here.

Re: Standard Horizon SL45 Knot Log Anomalies

matt_colie	23 Jul 2009 00:06
> I have a SL45 installed in a sailboat and it has worked perfectly up > until I took the boat into salt water. At sea it indicates 0.0 but [quoted text clipped - 7 lines] > thanks, > Dave Have you tried pulling it in and spinning it when it doesn't work? You just have to be fast to get the dumby plug in the hole. Matt

cowelld

22 Jul 2009 12:02

I have a SL45 installed in a sailboat and it has worked perfectly up
until I took the boat into salt water. At sea it indicates 0.0 but
back in fresh water it starts up again and works normally. Obviously
there's a short to ground in the sender although I don't think it has
a leak. Has anyone seen this effect? Either I'll have to go back into
salt to measure the current drain differences then paint the thing
with rubber to try and isolate it else buy another sender and hope
it's an isolated condition.

thanks,
Dave

Re: Standard Horizon SL45 Knot Log Anomalies

Quick links: